Metal sheet cutter fittings

Packing size: about 240 * 140 * 55mm

Technical parameters:

1. There are two head can be turned to cut

2. The head can be positioned 360 degrees in any direction

3. Electric or pneumatic drill, 1500-3000 rpm

4. Minimum cutting radius 12 mm

Allowable Cut Thickness Reference

Ordinary iron plate: 1.8 mm

Stainless steel plate: 1.5mm

Copper, aluminum plate: 2mm

Plastic plywood: 2 mm

Sheet Hole Opener Instructions:

1. When equipped with a thin plate hole opener, first of all, the electric drill front end and cutter, insert the hole in the hole of the hole opener to connect the cutter with the drill and lock it, and then tighten the three screws on the shelf to prevent the hole opening shelf from sliding; Insert the ruler rod into the small square hole of the shelf with the positioning needle upward from left to right, and finally adjust and twist the top screw tightly according to the size of the cut arc, and fix the ruler pole firmly to ensure the accuracy of cutting the round hole.

2. When cutting the standard arc, the thin plate opener should be used to ensure the smooth and beautiful cutting surface of the arc. It should also drill a 3 mm positioning eye at work, and then drill a 12 mm hole, and extend the cutter head into the hole to cut the inner and outer circles.

Note: the main machine is all metal material; Handle material is plastic.

1. The cutting edge of the blade is often refueled, especially for cutting aluminum plates.

2. First open the drill, after cutting, the end of the first exit after closing the drill.

3. When cutting, the cut of the cutter bar must be kept perpendicular to the workpiece to prevent the head from breaking.

4. Arbor replacement: open the protective cover, take out the anti-loosening nut, loosen the fastening screw, use pliers to pull out the arbor, re-install the argil, tighten the screw that is

But...