Product description
50pcs replacement steel pins for floor wall tile leveling system leveler replaceable pin tiling construction tool 1.5mm /0.9mmfor wall floor
*1. Durable and recyclable
*2. Easy to use in DIY operations.
*3. Balance the tiles in the same horizontal position.
*4. Improve the installation speed of tiles.
*5. Reduce installer fatigue/stress.
*6. There are hardly any crack-free flat surfaces.
*7. It reduces the need for grinding and polishing.
*8. Prevent the tiles from moving during the setting process.
Name: Steel needle for tile leveling system
Material: Stainless steel
Steel needle length: 32mm/1.26"
Steel needle thickness: about 1.5mm/0.9mm
Lay the first tile, leaving more than 2mm (with cross washer). close to the tiles.
Insert T-pins along the gaps between the tiles.
Then rotate 180 degrees and the T-pin snaps to the bottom of both tiles.
Adjust the cover with a hand/special wrench until the two tiles are on the same level.
After leveling, about 5-6 hours, before the cement/adhesive is completely dry, reverse the cover and remove the 180 degree T-pin until the lettering is removed.
Avoid not removing the T-tile leveling system:
1. Tile spacer is more than 2mm (cross spacer is recommended)
2. When leveling, the cement or tile adhesive around the T-type leveling machine must be cleaned up.
3. About 5-6 hours after leveling, before the tile adhesive or cement is completely dry, remove the T-straighter.
*1. This item contains only steel needles, not straighteners. The straightener in the picture is just the effect used.
*2. Due to various factors such as the brightness of your monitor and the brightness of the light, the actual color of the item may vary slightly from the image displayed on the website.
*3. Please allow for slight manual measurement bias in the data.