300W Hot Air Heat Gun Electric Power Temperature Blower Mini Tool for DIY Shrink Tubing Soldering Wrap Plastic Rubber Stamp

Main Product: Hot Air Gun

Plug Type: EU Plug / US Plug (optional)

Heat Gun Power: 300W

Achievable Temperature: 200℃

Rated Voltage: 220V / 110V

Widely Application: DIY Craft Embossing, Shrink Wrapping PVC, Drying Paint, Clay, Rubber Stamp, etc

 

# About This Item

Mini Heat Gun:

Dimensions 225x45mm / 8.86x1.77in (Approx.) 3.28FT Long Cable (Approx.)

Safety Hot Air Gun:

Mini Craft Heat Gun for Epoxy Resin adopts anti-scalding non-slip handles on the outside, independent switch buttons, and high-quality stainless steel air outlets and stainless steel brackets inside, making the use process safer.

Cooling Holes:

The temp of the nozzle could reach 200° in seconds. The vent at the rear can reduce the internal high temperature and prolong the service life.

Easy to Use:

 

The handing part adopts salient point nonskid designs that cause safe handholding with small energizing!

 

# How to Use the Heat Tool

Plug in the heat tool. Hold the product as shown on the pict. (Do not touch the hot nozzle.)

Keeping 3-5cm distance from work and about a 45-degree angle to heat until it is completed. (Do not blow the hot air gun directly at 90° to the object.)

 

 

Warm Tips:

The temp of the nozzle could reach 200° in seconds, please don't use it for more than 10 minutes at one time.

If the temperature of the fuselage increases significantly, please close the heat gun and wait for cooling before using it.

It can not be usedin industrial aspects such as disassembly and welding of small iron sheet components and patch integrated circuits.

 

# Package List