Product description
1. Please prepare the cable like picture P1 and strip the isolation to 9-10mm. The cable cross-section must be between 0.33 and 2.08mm²(AWG22-14).
2. Now push down the terminal with a screwdriver and put in the cable.
3. Take the screwdriver away and the cable is connected with the terminal.
1. Connect the LED product to the controller see section "wire connection".
2. Start the device searching on the ZigBee light link Gateway, it could take some time.
If the Gateway does not find the device, plug power off/on or make a reset.
3. The Gateway found your device and you can assign it to the different rooms/zones/groups.
4. Now you can use the device.
1. Switch on your device.
2. Now switch off and on within 2 seconds.
3. Repeat off/on four times.
4. Reset is done when the device is switched on in the fifth time and the light stays on after blinking 4 times.
Type: Zigbee Strip Controller
Input Voltage: DC 12V-24V
Output Current: Max. 6A/CH
Total Output Current: Max. 15A
Max. Load Power: 180W (12V)/360W (24V)
Remote Distance: 10~15 Meters
Connecting Mode: Common Anode
Connection Mode: APP Control
Features: Common Anode, Constant Voltage, Compact Size
Size: 23.5mm x 45mm x 89mm/0.93" x 1.77" x 3.50" (Approx.)
Due to the light and screen setting difference, the item's color may be slightly different from the pictures.
Please allow slight dimension difference due to different manual measurement.
1 x Zigbee Strip Controller