180cm Privacy Film Vinyl One Way Mirror Windowl Self-Adhesive Reflective Solar Window Film For Home Office 96%UV Block Glass Chameleon Staining Film

About this item:

 

【Insulation & energy-saving 】 Our Privacy Window Film protects against 90% infrared radiation. And expensive cold for you to enjoy at home.

 

【Static cling & non adhesive】 this window adhesive for glass window uses adhesive, no chemical release, very easy to install, just make sure the window surface is absolutely clean and without any impurities. To soak both sides of the adhesive and window, useful light block sticker for your window glass.

 

【Daytime】 please note that one-way window glass only gives good privacy during the day and the outer glass shows the mirror effect. but the mirror effect is reversed at night as inside is more exposed to light.

 

【Thick and high quality】 2mm thick decorative reflective window film. To provide excellent insulation effect with a scratch-resistant layer on the surface, wear-resisting, friction-not fade or blister-proof, easy to remove, economical and practical.

 

【Easy removable window film 】 it is very easy to remove the privacy film of the window at home without any damage to yourself or any stain on any glass, many sizes for you to choose.

 

 

How to remove clear backup film:

 

Step 1-please wet the window film corner and use your finger to twist for a moment to unconnect between window film and clear backup film.

 

Step 2-please attach the adhesive tape to the side of the corner.

 

Step 3-then you can easily separate the clear backup film from the window film.

 

 

Installation instructions:

 

1. measure the surface and cut the film, leaving one inch special gap on each side for easy adjustment.

 

2. thoroughly clean the target surface and make sure the surface is clean enough without dust.

 

3. peel off the transparent backing film, take out the short side (very important!!!)

 

4. spray water or soap water on both sides of the glass and then stick the glass film on the glass.

 

5. Use a soft towel or squeegee to wipe the film back and forth to ensure bubbles and water are completely removed.

 

6. cut the edges and use the fabric to make the film flat here you go!

 

PS

1. we will cut and pack more than two separate orders. Please check the packaging carefully.