【Ready Stock】10pieces hardware Pressing Tile leveling tool adjustment Leveling Tiling Clip location plastic Floor tiles handtool

Suggest using with a cross

It is recommended to use multiple gaps in one tile

Usage steps:

1. Adjust the position of the L-shaped needle to leave a gap of>1.5mm, and use it with a cross card for better results

2. Insert an L-shaped needle along the gap, rotate it 90 degrees to clamp the needle at the bottom of the brick, and fasten the handle to level it

3. Within 3-5 hours of construction, rotate 90 degrees in reverse to remove the tile adhesive before it solidifies

4. The leveling effect is completed, and the surface of the ceramic tiles is flat and beautiful

Advantages:

1. Multi position adjustment checkpoint

Suitable for multi-point leveling of 8-12mm ceramic tiles with different thicknesses

2. Recycling without waste

After leveling, rotate the T-shaped needle 90 ° to remove and reuse it

3. Quenching process, T-shaped steel nails

Practical high strength without deformation, rotating without damaging bricks

4. Replaceable T-shaped steel needle

During the process of extending the service life, if deformation or damage is found to the steel nails, they can be freely replaced to prolong the service life

(1. Use a Phillips screwdriver to remove the screw. 2. After removing the screw, replace the T-shaped nail.)

Notes:

How to avoid the inability to remove the T-shaped leveler

① Leave a seam of 1.5mm. You can directly use a leveling tool to leave a seam. If you need to leave a seam of 2mm or more (it must be used in conjunction with the cross card provided by our store)

② When leveling, rotate the steel needle left and right, and be sure to clean the surrounding cement

③ Do not fill the gaps in the bricks with cement, otherwise in case they are taken out late, the cement will dry and the steel needle cannot be pulled out

(4) 4-6 hours after leveling, be sure to remove the leveling tool before the cement or tile adhesive is completely dry