100% Light Blocking Darkest Film Static Total Blackout Glass Privacy Darkening Tint Black Window Sticker

Adhesive Free: Easy to install without any glue, firmly attached to the glass with water.

Reusable: Easy to remove and reuse, no residue left.

Uv Rejection: Protect your family from harmful UV rays, slow down furniture fading.

Heat Control: Keep cool in summer, maintain heat in winter.

8 Installation Steps:

1.Measure and record target mirror size.

2.Clean the glass thoroughly.

3.Add 1+ inches on all sides when cutting the film to give you the excess film to trim.

4.Peel off the backup liner.

5.Spray soapy water onto glass and light filter film generally.

6.Place the film on the wet glass, adjust the position of the optical film.

7.Use a plastic squeegee or card start to squeeze water and air out from under the film.

8.Cut off the excess material with a very sharp scraper or craft knife, leaving 1/16" wide gaps around the edge of the film.

Uestions and answers

1. How to deal with air bubbles?

Use hard plastic squeegee or plastic card to squeeze bubbles and water. If you find it difficult to remove air bubbles, open the light filter film, spray more water between the glass and the film and squeeze the water tightly again. The water will make it easier to remove air bubbles.

2. Why did this movie fall off after a while?

Please confirm if you remove the liner, trim the edge or squeeze excess water and air bubbles.

3. Can I take the film out for the stage later?

Of course, our solid film is removable and reusable. You can peel the film off the glass in seconds without messing up.

4. Can I see outside after I put this movie in?

No, this movie provides 2 ways privacy which means you can't see through either indoor or outdoor viewing.

Key features:

Adhesive Free: Easy to install without any glue, firmly attached to the glass with water.

Reusable: Easy to remove and reuse, no residue left.

Uv Rejection: Protect your family from harmful UV rays, slow down furniture fading.

Heat Control: Keep cool in summer, maintain heat in winter.

8 Installation Steps:

1.Measure and record target mirror size.

2.Clean the glass thoroughly.

3.Add 1+ inches on all sides when cutting the film to give you the excess film to trim.

4.Peel off the backup liner.

5.Spray soapy water onto glass and light filter film generally.

6.Place the film on the wet glass, adjust the position of the optical film.

7.Use a plastic squeegee or card start to squeeze water and air out from under the film.

8.Cut off the excess material with a very sharp scraper or craft knife, leaving 1/16" wide gaps around the edge of the film.

Uestions and answers

1. How to deal with air bubbles?

Use hard plastic squeegee or plastic card to squeeze bubbles and water. If you find it difficult to remove air bubbles, open the light filter film, spray more water between the glass and the film and squeeze the water tightly again. The water will make it easier to remove air bubbles.

2. Why did this movie fall off after a while?

Please confirm if you remove the liner, trim the edge or squeeze excess water and air bubbles.

3. Can I take the film out for the stage later?

Of course, our solid film is removable and reusable. You can peel the film off the glass in seconds without messing up.

4. Can I see outside after I put this movie in?