Electronic Module 4000W 220V AC Motor Speed Controller Module Voltage Regulator Temperature Dimming Electric Furnace Water Heater

High Power: 4000W (Limiting Power of Resistive Load). Power Usage Should Be Reduced for a Long Time. It Is Recommended to Use It Within 2000W of Room Temperature Resistive Load (Please Pay Attention to the Key Parameters).

4000W Pressure Regulator Voltage Regulation Range Can Be Smoothly Adjustable from 10v-220v, Which Is More Suitable for Industrial Enterprises That Need Low Voltage Drive Heating Wire.

Specifications:

Product Name: 4000W AC Pressure Regulator

Silicon Controlled Rectifier Model: Bta41600b

Size: Length 85 * Width 55 * Height 38mm, Knob Inner Hole 6mm.

High Power: 4000W (Resistance Load Limit Power), Power Usage Should Be Reduced for a Long Time.

Efficiency: More than 90%

Working Voltage: AC 220V

Regulated Voltage: AC 10-220V

Note That the Load Must Be Connected before Voltage Regulation.

Silicon Controlled Rectifier Is Mainly Used for Resistance Loads (Heating Wire Incandescent Lamp, Etc.). Most Single-Phase AC Motor Is OK, but It Is Not Guaranteed. Buyers Should Confirm Other Types of Loads by Themselves. Fuse Is Not, There Is Reaction Time, If the Current Is Too Large, in Addition to Burn out Fuse, Module May Also Burn out.

Note That the Plastic Cover on the Connector Cannot Be Completely Opened Due to the Installation of the Shell. the Screwdriver Should Be Twisted Slightly. In Addition, Be Careful When Lifting It. If the Force Is Too Large, It Is Easy to Break the Cover. Express Transportation May Also Be Crushed, it Is a Vulnerable Part, but It Will Not Affect the Use of the Module. We Will Not Be Responsible for Returning Or Returning Any Plastic Cover-Related Problems.

Internal Image:

Pressure Regulator Size: Length 85mm * Width 55mm * Height 35mm

Pressure Regulator with Shell and Fuse Is Safer, More Convenient to Install, and More Suitable for Families and Factories and Enterprises That Are Not Convenient to Install.

Use Original Imported 41A Silicon Controlled Rectifier.

Using 1.6 Thick FR-4 High Temperature Resistant Circuit Board, the Circuit Design Is Reasonable, and the Welding Circuit Design with plus-Sized Thick Is Adopted. Even If the Large Current Passes through, It Is Enough to Deal with It, Which Is Safer and More Reliable to Use.

The Standard 35A 4-Position Terminal Is Adopted, Which Is Only 4000W Design. (Two in and Two out Are More Convenient for Wiring).

The Circuit Has Been Improved Many Times and Selected Every Accessory. Now the Technology Is Fully Mature. Double Capacitor Design (Safety Capacitor + Metal Film Capacitor) Is Adopted to Effectively Absorb Surge and Voltage Rush, More Effectively Protect Silicon Controlled Rectifier, and the Use Efficiency Is Higher and Safer.