Product description
Voltages Calibration: input terminals is connection to 30VDC (only the 30V voltages). The two solder joints on the upper right corner of the display shall be calibration for more than 1 second. The digital display will stop after the flashing of CA-L.
Stop setting ≦11V, ≥ 14V start, ≥ 15V stop.
Open within the ranges of 10.5V to 12V, and close others (stop at low-voltage ≦10.4V, stop at high-voltage ≧12.1V).
Overvoltage setting ranges (HV-key) :6-80V- no-limit (display --), the factory default is no-limit. In addition, the overvoltage should be greater than the release voltages. If the setting cannot be "+ or -", check whether the HV-key setting value is appropriate.
How to use:Battery overdischarge voltages setting, because of different load, the cut-off voltages is also different, according to their own in actual use to measure cut-off voltages value, the premise is that cut-off voltages must be greater than the battery overdischarge voltages.
Name: Battery DC Voltages Protections Module
Output-voltage: equal to the supply voltages, DC6V-80V
Max-input: DC80V(note: Input voltages higher-than 80V May be permanently damaged)
Power Consumption: less than 1.5W
Protections: Input terminals voltages positive and negative polarity is reversed, automatic protection and no display or output. (Note: If the input connection is correct, the output terminals has no protection if the polarity of the output terminals connection is reversed)
Display-mode: three-position 0.36" LED digital tube
Material: Printed Circuit Board
Size: Approx. 57x42mm/2.24x1.65inch
Applicable to all electric two-wheeled three-wheeler battery within voltage-range
Automobile battery discharge protections
All kinds of storage battery overdischarge protections
Solar, wind and other power supply system
Various equipment input-voltage protections
Please allow 0-1cm size error.
1x Voltages Protections Module