Product description
Wear-resistant, recyclable.
Easy to use in DIY operation.
Balance tiles in the same horizontal position.
Improve the installation speed of tile.
Reduce the /pressure of installers.
There is hardly any crackless, flat surface.
It reduces the need for grinding and polishing.
Prevent tiles from moving during solidification.
Name: Steel s for Tile Leveling System
Material: stainless steel
Length of steel : 32mm/1.26"
Thickness of steel : about 1.5mm
Lay the first tile, leaving more than 2mm (with gaskets). Close to tile.
Insert T-pins along the gap between tiles.
Then rotate 180 degrees and the T- is stuck at the bottom of the two tiles.
Adjust the lid with a hand/special wrench until the two tiles are on the same level.
After leveling, about 5-6 hours, before the cement/binder is completely dry, rotate the lid in reverse and take out the 180 degree T until the word is removed.
Avoid not removing the T-tile leveling system:
1. Ceramic tile gaskets are 2mm or more ( gaskets are recommended)
2. When leveling, the cement or tile adhesives around T-type leveller must be cleaned.
3. Remove the T-type straightener about 5-6 hours after leveling before the tile binder or cement is completely dried.