AC110V 120V 220V Timer Infinite Cycle delay Turn ON/OFF Time Relay Switch Module

Product Description: Brand new high quality Made of high-quality materials for durability AC110V 120V 220V Timer Infinite Loop Delay On/Off Time Relay Switch Module With start/stop function, the module enters infinite loop mode after startup, and the relay is in accordance with the set time. scope: Voltage: AC 100V-250V, can be used for 100V/110V/120V/127V/220V/230V/240V power supply. Power consumption: Output: Active output, the output voltage is the same as the input voltage. The maximum does not exceed 10A. Life: 100,000 times Input: passive switch input, start with green light and stop with red light Time range: 0.5 seconds - 1000 minutes Time for precision: range Max*0.001, or 1000 resolution. Input (start key): passive switch input, the green light is on first after starting, and the red light stops when it stops. - No start input required, you can connect the two terminals with a short wire, This way the power will cycle indefinitely, with no buttons. Size: length 88mm*width 38mm*height 22mm or less Screw hole: center distance 83mm*33mm, hole diameter 3.2mm terminal: <-L Power L line (live) input <-N Power N line (neutral line) input 1> output N, load N line 1> Output: L1, load L line Most appliances do not need to strictly distinguish the LN line 1> LNC L line output is normally closed, generally not connected. Instructions: 1.ON time setting: The potentiometer adjustment time is marked under RUN TIME, clockwise is to increase the length, Decrease time counterclockwise. The potentiometer DIP switch is set to the left time range. The adjustable range of adjustable resistance is 0-100; The dial range is 0-1000. The potentiometer DIP switch unit is set correctly. Dial to seconds. Seconds indicate units; dial to Min. to The indicated unit is minutes. 2.OFF time setting: The potentiometer adjustment time is marked under OFF TIME, clockwise is to increase the length, Decrease time counterclockwise. The potentiometer DIP switch is set to the left time range. The adjustable range of adjustable resistance is 0-100; The dial range is 0-1000. The potentiometer DIP switch unit is set correctly. Dial to seconds. Seconds indicate units; dial to Min. to The indicated unit is minutes. 3 Start button: Access the reset button, click, switch to the green light, indicating the running state, the module will automatically Stop work according to the running time and time length setting, infinite loop. Click the start button again, The module will switch to a red light, indicating that it is in a stopped state. 4 Example of time setting: Requirements: connect for 20 seconds, disconnect for 30 minutes, infinite loop. set up: (1). Set the running time range to 0-100; (2) Set the running time unit to seconds; (3) Turn the running time potentiometer to the left 20/100 position; (4). Set the stop time range to 0-100; (5) Set the stop time unit as minutes; (6) Turn the stop time potentiometer to the position of 30, that is, the position of 30/100 from the left; application: For cyclic controls, or equipment, product burn-in testing repeats power up/down. notes: 1. If you need to start the button, the button capacity needs to be above 0.1A 2. AC power supply, pay attention to safety Package Included: 1 * Relay Module Note: 1.The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness. 2.Please allow slight manual measurement deviation for the data.