Chimney Accessories, 100/150/200mm Brush Head, 400/570mm Rod, Hexagonal Rod,Cleaning Tools

If you receive the rod is white and hard. Don't worry, if you leave it exposed in the air for a period of time, it will absorb moisture in the air and become soft it needs to last about a month. Because the white rod is just produced. The newly produced PA material is hard.

How to use:

1. Connect a sufficient number of rods as needed;

2. Install the brush head on the rod, if you use a power drill, go ahead and install the hex rod;

3. When you start off go slow and clean out 2-3 feet at a time and pull the brush back towards you to bring all the dust junk back to or down to you. Going vertical to push the junk out won't work. However horizontal may work for you.

4. Get someone to do the drill work for you as you guide the rod and brush in and out of the pipe. As you go in pull it back and forth and then go in further. Once you have done about 3 feet pull it all back out to bring the junk back to you.

5. WEAR A MASK !! There will be dust everywhere. It will smell like fabric softener everywhere.

WARNING: Never force the brush/rod assembly through the duct! If it should become jammed, pull assembly away from constricted area a few inches still rotating in a clockwise direction then slowly push forward.

WARNING:Please do not bend the rod connecting the electric drill. If you have to bend, the bending angle should not exceed 30 , and please turn it at a very, very slow speed. Otherwise, the product will be damaged by you!

WARNING: When the length of the rod is greater than the length you need to use. Please remove the extra rods. Otherwise, the redundant rods will be twisted together due to the rotation of the electric drill, and the rods will be damaged!

Attention:

How to buy in combination