DC 0-100V 10A Voltmeter Ammeter Dual Digital Volt for Amp Meter Gauge 3 Bit

* quality and brand new.

* Two-meter compact voltage and current can be displayed on the same screen at the same time.

* The meter head adopts a design, and the ground wire measurement end is the same as the power side ground wire.

* The power supply range of the meter: DC4.5~30V, the power supply is reversed and does not burn.

* There are five wires on the strap, which are convenient for connecting to the car/battery car/motorcycle line. It is monitor the battery voltage and master the battery voltage status.Other products can be for voltage and current measurement.

Specification:

Supply voltage: 4.5 30V(wide range)

Test voltage: 0～100V; Minimum resolution: 0.1V

Test current range:

2A, 5A, 10A resolution: 0.01A(no external shunt is required for direct measurement), continuous operation of more than 5A, such as long-term full load, it is recommended directly solder the measurement end the socket

50A, 100A Resolution: 0.1A

100A: 1A

Header 10A- requires external shunt(purchased separately)

Working current:

Test current: 50A

Display: 0.28 inch single color(red), double color(red and )

Size: 48×29×21mm

Mounting cutout: 45.5×26.5 mm

Measurement rate:≥500mS/time

Measurement accuracy: 1%(±1 word)

Extreme working conditions:

Minimum supply voltage:+4.5 V

Maximum supply voltage:+30 V

Operating temperature:-10+65

Operating humidity: 10 80%(non-condensing)

Working pressure: 80～106kPa

Sun exposure: Do not expose directly the sun

Connection Type:

*Power connector: two-wire socket

*Powered Ground Thin- Black Wire: Header

Thin-red wire: meter head(note that the voltage between the thin red wire and the black wire cannot exceed 30V for power supply)

Test end: three-wire socket

COM- Black Line: End of for Beta

PW+- red line: measure the positive voltage input

IN+——yellow wire: current input terminal; the main meter head is designed, the ground wire of the measurement terminal and the ground wire of the power supply terminal are the same, so it is only connected between the negative pole of the device under test and the negative pole of the power supply, as shown in the figure, if it is wrongly connected Burned out(such as a single voltmeter, it is recommended that the yellow wire and the black wire be together external interference from causing the ammeter number)

Package Included:

1 x 2 IN 1 for Ultra Mini Digital Ampere/Volt for combo Meter 10A